STF SURFTAPE ®  FEEDER For 8,12 and 16mm Surftapes Easy handling of dies For handling of dies in a standard-pick & place system the surfape®  feeder is a cost-effective solution and easy to handle. Dies   are   dispensed   with   the   active   side   facing   up.   A   push-up   tool   in the   surface   feeder   lifts   up   the   dies   from   the   sticky   tape   rails   for transfer to the pick head of the assembly placement machine. The surftape feeder requires a space of only 30 mm in the pick & place system. It is especially beneficial when many different dies have to be applied on a PC Board.
Specialist feeders manufactured in the UK
Surftape ®  Feeder with Panasonic interface
Speci
Specification of the Surftape Feeder STF
Compatible with pick and place systems
Siplace (X series with ASM adaptor) and Panasonic NPM.
Tape widths
8 / 12 / 16mm surftape
Recommended tape sizes
8mm surftape: BE 1 x 1 mm - 2.3 x 2.3mm
12mm surftape: BE 2.3mm x 2.3mm - 5 x 5mm
16mm surftape: BE 3.8 x 3.8mm - 9.5 x 9.5mm
Placement accuracy of the bare dies on the surf tape:
Required distance of corners bare DIE - tape pocket
Poke up needle
Tape material
Bare DIE size up to 2.3mm x 2.3mm: ± 100µm  6Ó Bare DIE  size greater than 2.3mm x 2.3mm: ± 200µm  6Ó (in relation to the centre of the pocket)
Minimum 0.4mm
Single or triple needle depending on the size of the DIE
Surftape metrisch
Tape standard
Reel diameter
IEC 286-3, DIN-IEC-286, EIA 481 and JIS C 0806
7” up to 15”
Required feeder space for SST
1 track on the component table
Specialist feeders manufactured in the UK
Welcome

Id qui et pariatur, in, culpa magna ex ea

aute ipsum voluptate tempor proident

cupidatat nostrud.

STF SURFTAPE ®  FEEDER For 8,12 and 16mm Surftapes Easy handling of dies For handling of dies in a standard-pick & place system the surfape®  feeder is a cost-effective solution and easy to handle. Dies   are   dispensed   with   the   active   side   facing   up.   A   push-up   tool   in the   surface   feeder   lifts   up   the   dies   from   the   sticky   tape   rails   for transfer to the pick head of the assembly placement machine. The surftape feeder requires a space of only 30 mm in the pick & place system. It is especially beneficial when many different dies have to be applied on a PC Board.